XIT OFFROAD Polaris Ranger AA Revolver Clutch Plate Kasutusjuhend

Revolver Primary Cover

for RZR XP1000, 1000S, 900

General, ranger & more

ank you for purchasing your Revolver clutch cover from AA! e cover is made to t on the original clutch made by Team Industries found

on many models. is includes: 2014 + RZR XP 1000, RZR 1000 S(trail), General, General XP, RZR 900 S/XC/Trail, and Ranger 900 models.

is cover is designed to strengthen the clutch with its more rigid design and tower lock system. e tower lock system is designed to prevent

clutch tower ex, providing a more rigid clutch design. e Revolver clutch cover is also designed to move more air through your clutch cover

with the larger ns on the plate. See below for steps on easy installation.

Parts included: Revolver cover, 2 primary clutch limiter shims

• Remove the clutch cover duct and clutch cover from the vehicle

• Locate the 6 bolts holding the factory spring cover in place and remove them carefully as you have some spring tension under the cover

• Install the supplied 2 limiter washers on the center post. You may already have 1-2 of these limiter washers from the factory. To prevent

over travel of the clutch, make sure you add the AA ones.

• Install the AA Revolver clutch cover in place of the factory cover with stock bolts

• ere is no orientation needed (no X) on our cover

• Torque the factory bolts to 9-10-lbs

• Install your clutch cover and go ride!

Laadige alla PDF