Brother BE-1204C Quick Reference Manual

Brother
Bränd
Brother
Mudel
BE-1204C
Tüüp
Quick Reference Manual

See käsiraamat sobib ka

1
Quick Reference Guide For Sewing A Design
Loading a design from a floppy disk (DST file).
1. Turn on computer and start the Brother Embroidery System software, ECSC.
2. Turn on the Brother machine.
3. Insert the floppy design disk into the computer disk drive.
4. Left click on the Explorer icon.
B
B
E
E
-
-
1
1
2
2
0
0
4
4
/
/
1
1
2
2
0
0
6
6
L
L
o
o
a
a
d
d
i
i
n
n
g
g
a
a
*
*
.
.
d
d
s
s
t
t
f
f
i
i
l
l
e
e
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
Explorer Icon
2
5. On the left hand side of the window, left click on the 3 1/2 Floppy (A:)
6. On the right hand side of the window, double left click on the design that you want to load.
3
7. A create icon window will be displayed. Just left click on OK.
8. How many times is feed required before thread trimming is to be performed? 3 is the standard so
just left click on OK again.
9. Move pattern to current needle position? Press cancel to have the design start in the center of the
embroidery area.
4
Setting color sequence
1. Left click on the Needle Bar Change icon.
2. Left click and drag each color change in the design over the needle bar number on machine that
you want that color to be.
3. When finished, left click on the Needle Bar Change icon again to turn off the color sequence
window.
N
eedle Bar Change
Nee
dle bars on machine
Color chan
es in desi
n
5
Loading embroidery hoop and positioning of design
1. Left click on Settings.
2. Left click on Load Hoop.
6
3. Double left click on the hoop that you wish to use and make sure the design fits within the light
green line inside the hoop outline.
Setting Speed
1. All newly loaded designs will default to speed range 1 (1000spm) when they are loaded. Left click
on the down arrow to lower the speed to 800 spm for tubular or 700 spm for caps.
7
Sending design to the machine
1. Left click on the start button to send design over to machine.
Operations on machine panel
1. If “HOOP” is displayed on the machine panel, press
.
2. Press
again to confirm position of design within the hoop.
3. Press the
button to start the embroidery process.
Revised 2/22/05
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Brother BE-1204C Quick Reference Manual

Brother
Bränd
Brother
Mudel
BE-1204C
Tüüp
Quick Reference Manual
See käsiraamat sobib ka
Laadige alla PDF
aruanne

teistes keeltes

Seotud paberid

Muud dokumendid