RG4CH-AA Installation Instructions

Hogtunes Inc., Unit 14 - 70 Ellis Drive, Barrie, Ontario, Canada, L4N-8Z3

Tel: (705) - 719-6361 Email: info@hogtunes.com

www.hogtunes.com

The RG4CH-AA properly installs a Hogtunes NCA 450-AA amplier in 1998-2013 (non CVO) Road Glides.

It can also be used to mount any Hogtunes 2 channel amp or Hogtunes NCA 40.4 in the same location.

If Installing a Hogtunes REV 200-AA or NCA 70.2

Using the supplied nuts and screws, attach the amplier

the adhesive does most of the work. Follow amplier

manual for wiring instructions.

Step 1) Turn the NCA 450-AA over and remove the 4 screws

(shown above) on the power connector side of the amplier

Step 2) Put the plate over the amp as shown above and

reinstall 4 screws into holes marked “B”. Apply 1 side of

hook and loop in area shown on plate.

Step 3) Clean area on inner fairing where other half of

hook and loop adhesive will go. The bolts that hold the

turn signals in place will secure the plate even though

plate as shown in above using holes marked “A”. The

screws will go direct into the underside of amp. Apply 1

side of hook and loop in area shown on plate. Clean area

on inner fairing where other half of hook and loop adhe-

sive will go. The bolts that hold the turn signals in place

will secure the plate even though the adhesive does

most of the work. Follow amplier manual for wiring

instructions.