10 / EN Cooker Hood / User Manual
4 Cleaning and maintenance
B
Risk of burning, risk of electric
shock!
Wait for the appliance to cool down
before cleaning or maintenance
works. Shut down the fuse or un-
plug the appliance. Risk of damage
occurs due to the humidity intrusion
into the electronics. Never clean the
controllers with a wet cloth. Surface
may be damaged due to improper
cleaning. Clean the stainless steel
surfaces only in the direction of
brushing. Do not use stainless steel
cleaner for controllers. The surface
may be damaged due to abrasive or
rubbing cleaning agents. Never use
abrasive or rubbing cleaning agents.
A
Risk of damage due to the corro-
sion damage. Always operate the
appliance while cooking in order
to prevent condensate formation.
Condensate may cause corrosion
damage. Replace immediately the
faulty lamps in order to prevent oth-
er lamps from being overloaded. The
risk of damage occurs due to the
humidity intrusion to the electronics.
Never clean the controllers with a
wet cloth. Surface may be damaged
due to improper cleaning. Clean the
stainless steel surfaces only in the
direction of brushing. Do not use
stainless steel cleaner for control-
lers. The surface may be damaged
due to abrasive or rubbing cleaning
agents. Never use abrasive or rub-
bing cleaning agents. There is the
risk of damage due to backflow of
condensate. Install the air outlet duct
with a slope of 1°, slightly down-
wards the appliance.
AYou can use this appliance in waste
air mode and in air circulation mode.
A
Waste air mode
Absorbed air is cleaned by oil filters
and expelled by means of a piping
system. If you want to transfer the
waste air to a disabled smoke or
waste gas flue, you have to obtain
permission from an authorised flue
cleaning specialist. If the waste air is
expelled over the external wall, a tel-
escopic wall frame should be used.
C
•Absorbed air is cleaned by oil fil-
ters and an active carbon filter and
retransferred to the kitchen.
•The waste air should not be trans-
ferred to a smoke or waste gas
flue, nor to a flue used for venti-
lation of the places where heating
sources are installed.
•To seal the materials causing
odour in the circulating air mode,
you should install an active car-
bon filter. Consult your authorised
dealer to learn different opportuni-
ties for operating the appliance in
the circulating air mode. You can
buy accessories necessary for this
procedure from relevant points of
sale, authorised service agents or
online sales centre.