1
INNOVAC AQUA PLUS
CORDLESS STICK VACUUM AND WET MOP HS1-SWB
EN ·Instruction manual NL ·Instructies
NO ·Bruksanvisning PL ·Instrukcje
SE ·Bruksanvisning FR ·Instructions
DK ·Betjeningsvejledning IT ·Manuale di istruzioni
FI ·Käyttöohje ES ·Manual de instrucciones
DE ·Anleitung
NO
SE
DK
FI
EN
NL
PL
FR
IT
ES
DE
LES ALLE ANVISNINGER FØR BRUK
LÄS IGENOM ALLA INSTRUKTIONER INNAN PRODUKTEN ANVÄNDS
LÆS ALLE VEJLEDNINGER INDEN BRUG
LUE OHJEET HUOLELLISESTI ENNEN KÄYTTÖÄ
READ ALL INSTRUCTIONS BEFORE USE
LEES VÓÓR GEBRUIK ALLE INSTRUCTIES
PRZED UŻYCIEM ZAPOZNAĆ SIĘ ZE WSZYSTKIMI ZALECENIAMI
PRENEZ CONNAISSANCE DE TOUTES LES INSTRUCTIONS AVANT UTILISATION
LEGGERE TUTTE LE ISTRUZIONI PRIMA DELL’USO
LEA TODAS LAS INSTRUCCIONES ANTES DE USAR
LESEN SIE DIE ANLEITUNG VOR DEM GEBRAUCH GRÜNDLICH DURCH
2
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
3
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
CONTENTS
4 IMPORTANT SAFETY INSTRUCTIONS
5 ATTENTION – BATTERY
6 ATTENTION – CLEANING AND MAINTENANCE
7 PRODUCT OVERVIEW
8 OPERATION
9 DISPLAY
10 CHARGING
11 CLEANING AND MAINTENANCE
15 TROUBLESHOOTING
18 GUARANTEE
19 PRODUCT SPECIFICATIONS
19 SUPPORT AND SPARE PARTS
19 RECYCLABILITY
4
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
IMPORTANT SAFETY INSTRUCTIONS
• This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack
of experience and knowledge if they have been
given supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children without supervision.
• This product is intended for indoor, non-industrial,
non-commercial, household use only.
• Do not use the item outdoors or for any other
purpose
• Suitable for dry locations only. Do not use outdoors
or on wet surfaces.
• Do not immerse in water.
• Do not use the hose if it is damaged.
• The plug must be removed from the socket-outlet
before cleaning or maintaining the appliance.
5
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
ATTENTION – BATTERY
• Do not charge the vacuum cleaner at the ambient
temperature of lower than 5°C and higher than
40°C.
• Let the vacuum cleaner cool down after use before
charging.
• If the low power icon is shown on the display after
turning the vacuum cleaner on, you should charge
the battery.
• When the battery is fully charged, disconnect the
power supply.
• If your vacuum cleaner is not used for a long time
(more than 2 months), please unplug it from the
power supply. In order to ensure the battery life,
it needs to be fully charged once every 2 months.
• Only use the maximum power when needed. Too
much usage on max will shorten the expected
battery life.
6
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
ATTENTION – CLEANING AND MAINTENANCE
• To ensure the suction force of your vacuum cleaner,
please clean the oor brush, brush rollers, lters,
and dustbin regularly.
• Make sure that all components are installed
properly, otherwise it could cause product failure.
• Do not let water get into the electric elements
of your vacuum cleaner, it could cause product
failure.
7
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
PRODUCT OVERVIEW
1. Main unit
2. Extension tube
3. Electric oor brush
Components:
4. 2- in 1 brush
5. Crevice nozzle
6. Power adapter
7. Wall mount
8. Mini power brush
9. Combo carpet brush
10. Telescopic crevice nozzle with
LED light
11. Wet mop attachment
12. Washable mop pad
13. Hard oor brush
1
2
3
4
5
6
7
10
11 12
8
9
13
8
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
OPERATION
• Press the power button to start.
• After switching the vacuum cleaner on, press the speed regulation button to
adjust the speed. The speed will go from Auto-High-Medium-Low.
• When using the Auto level, the dust sensing function is enabled. After sensing
dust, the background animation on the display will change from blue to
purple. If no dust is detected, the animation remains blue, and power will run
on low.
• The battery time is indicated by a circle on the display, divided into 6 sections.
As the battery is consumed the circle will lower section by section. When the
battery is low, the display shows “Low Power”.
Power button
Display
Speed regulation
MOP ATTACHMENT
1. Before use, attach the mop onto the tank. Fill the tank with water and
close the lid. Do not fill over the max indicator.
2. Attach the mop to the floor brush by placing the mop attachment on the
floor, and gently lower the electric floor brush onto the mop attachment
(see illustration)
3. Press the foot pump to pump water onto the mop to keep the mop
9
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
DISPLAY
Filter clean Dust tank blocking Roller blocking Air ow blocking
Air ow blocking Brush blocking Low speed Mid speed
High speed Low battery Charging nished Charging
damp. Wet the mop before attaching it to the mop attachment for a
better cleaning result.
• Store the mop attachment with an open lid to make it dry and to prevent
mould.
• The mop pads are machine washable at 40°. Clean after every use.
• Do not emerge the tank in water.
• Do not use floor cleaner.
• Do not use on wet surfaces.
10
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
CHARGING
1. Hang the vacuum cleaner on the wall rack
2. Connect the power cord to the charging port
3. Charge for 4–6 hours.
11
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
CLEANING AND MAINTENANCE
DUST CUP
Disassembly
Hold the bottom of the dust cup. Press the release button and carefully pull the
dust cup out downward.
Installation
Push the dust cup up with the suction inlet facing outward.
Release button
12
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
CLEANING
Press the Dust cup release button, and the bottom cover opens. Clean the dust
bin with water. Make sure it is completely dry before re-assembling.
FILTER COMPONENTS
1. Hold the ribs on both sides and pull upwards to remove the lter components.
2. Remove the lter sponge, lay it with the white side down and tap it to remove
dust.
Filter components
Open
13
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
3. Rinse the parts under water.
4. The parts needs to be completely dry before installing the lter components
into the dust bin.
DUST SENSOR
For the dust sensor to function optimally it needs to be cleaned regularly. To
clean the dust sensor just use your nger and remove the dust collected on the
sensor. The sensor is located inside the tube on two sides. Use your nger or a
dry towel to wipe over the sensors.
14
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
End cover button
FLOOR BRUSH
1. Press the button and remove the electric oor brush from the extension tube.
2. Press and hold the button and turn the end cover upwards.
3. Pull out the rolling brush and clean it. Do not use water!
15
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
TROUBLESHOOTING
Problem Possible reason Solution
Three indicators
ash
Rolling brush is tangled
by hair.
The ambient temperature
for operation is too high
or too low.
Remove hair or any foreign
object stuck in the rolling
brush.
Use the vacuum cleaner in the
proper environment.
Electric oor
brush is not
working
Large pieces of waste
have been engaged.
The rolling brush has been
tangled with hair.
Disassemble the electric oor
brush and remove the waste.
Remove the rolling brush
from the electric oor brush
and remove the hair from the
brush.
Operation
duration
becomes shorter
Battery aging
The ambient temperature
for operation is too high
or too low
The battery is not fully
charged
Contact customer service
Make sure the vacuum cleaner
is not placed in the sunlight if
it is too warm, and make sure
doors and windows are closed
if it is too cold.
Charge the battery
Suction force is
weakened
The lter sponge of the
dust cup is blocked
The suction inlet of the
oor brush or accessories
is blocked
The lter components
are not fully dried after
washing with water
Clean the lter sponge
Remove the objects blocking
the suction inlet
Make sure the lter
components are fully dried,
and assembled in the correct
way
16
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
Charging failure Ambient temperature
during charging is too
high or too low
Charge the appliance at the
proper temperature. Make
sure the vacuum cleaner is
not placed in the sunlight if it
is too warm, and make sure
doors and windows are closed
if it is too cold.
Battery liquid
leakage
The vacuum cleaner has
not been used for a long
time.
Change the battery. Contact
the store to replace the
battery.
Error on the
display
The vacuum cleaner is
lacking suction power.
This can be due to
something stuck inside
the extension tube, lter
being clogged with dust,
or that the rolling brush is
tangled with hair.
Remove any object in the
extension tube, clean the lter
components, and clear the
rolling brush for hair.
17
EN
CORDLESS VACUM WITH WET MOP · HS1-SWB
18
EN
INSTRUCTION MANUAL · INNOVAC AQUA PLUS
GUARANTEE
Wilfa issues a 5 year guarantee on this product from the day of purchase. The
guarantee covers production failure or defects that arise during the guarantee
period. Your purchase receipt works as proof towards retailer if claiming your
guarantee.
The guarantee is valid only for products that are bought and used in private
households. The guarantee is not valid if the product is used commercially.
The guarantee is not valid if the product is misused, used by negligence, if not
following instructions given by Wilfa, if modied or if unauthorized reparation
is done. Wilfa is not responsible for damage to third party parts and other
collateral damage.
The guarantee is also not valid for normal wear of the product, misuse, lack of
maintenance, use of wrong electrical voltage or:
• Overloading of product
• Parts which are normally worn down
• Parts you can expect being replaced regularly (e.g. lter, battery etc.)
• Wear parts like motor heads, nozzles, battery, brushes, lters, wheels, light.
Wilfa is also not responsible for damages occurred because of excessive use,
incorrect assembly, incorrect storage, incorrect charging, lack of cleaning etc.
The battery comes with a 1 year warranty. The warranty will not be valid if the
appliance has not been charged according to the manual.
/