Leht laaditakse ...
1
Start to Use--------------------------------------------------2
Put in/Take out battery----------------------------------2
Insert/Take out SIM card-------------------------------5
Battery Charging-----------------------------------------6
Your Phone--------------------------------------------------8
Stand by Mode--------------------------------------------8
Key Functions-------------------------------------------10
Voice Dial---------------------------------------------------13
Make an International Call---------------------------13
Dial extension No. of a Fixed line------------------13
Speed Dial------------------------------------------------13
2
Start to Use
Put in/Take out battery
Put in battery
1.Open the battery cover
2. Put battery into the battery slot. Keep three metal
points of battery facing downward and matching
with the three metal connection points on phone.
3
3. Put on battery cover. Make sure that cover is
completely matched and the cover matching sound
could be heard.
Take battery out
1. Open battery cover.
2. Press the battery side and lift it up to take it out
from battery slot.
4
3. Close the cover. Make sure that cover is
completely matched and the cover matching sound
could be heard.
5
Remark：Shut down all devices and cut the
connection with charger when removing battery.
Please use battery which is matched with this phone
only.
Insert/Take out SIM card
1. Insert SIM card：Remove battery cover； Insert
and slide the SIM card with the metal part facing
downward by following below arrow direction at
battery slot until SIM card is completely inserted in
right position.
2. Take out SIM card：Hold the notch of SIM card
and lift it slightly up by the other hand to take card
out.
6
Remark：Please note that you should use GSM
SIM card only, because it doesn’t support 3G.
Remark：Phone must be power off when put in and
take out battery.
SIM card and the contact point will be easily
damaged due to scratch and bending. Please be
careful when inserting and taking out the SIM card.
Battery Charging
Phone could be charged when phone is
power off or power
7
Make sure that battery is inserted in
phone before charging.
1. Plug in the charger.
2. Plug out the charger from power jack first after it
is charged. Then unplug charger from phone.
8
Remark：Battery indication will be displayed after
several minutes if battery is over-discharged.
Battery Level Indication Bar
Not enough battery alert
Phone will give alert when battery is not enough and
display a message of low battery on screen. Please
charge battery. Please charge battery when you
receive the alert of low battery during calling in order
to keep the calling.
Your Phone
Stand by Mode
When phone is ready to use but no operation is
done on phone, then phone is under stand by mode.
Charging
Charged
9
10
Icons on Screen
Icons might be displayed on screen.
Battery status
Signal status
Alarm
Message
Silent mode
General mode
Missed call
Key Functions
Key Key Name Functions
3
Navigation
Up key
Standby mode：press
to enter main menu
Operating ： press to
move cursor up
11
4
Answer Key
(Green key)
Press to make outgoing
call or press to pick up
phone when there is
incoming call.
Standby mode：press to
enter call list
5
Navigation
Down key
Standby mode：press
to enter phonebook
Operating ： press to
move cursor down
6
End Key
(Red Key)
Phone Off：
Long press to
switch on;
Phone On：
Long press to
switch off;
Operating：Press to go
back to idle screen
7
Numeric key
Press to
input numbers
or letters
12
8
* key
Standby mode：Long
press to lock the
keypad.Short press to
type in *，+,P.
Editing mode: Press to
use normal symbol.
9
# key
Standby mode
：
Long
press to set phone silent
mode, short press to type
in #.
Editing mode ：Press
to switch typing method.
10
Turn on/off
flashlight
Input digit 0 or long
press to open/Close
flashlight.
11
SOS
BUTTON
Insert SIM card and Long
press to dial emergency
call
13
Voice Dial
Make an International Call
1. Press 0 key for twice times and sign “+ ” will
come out. Then enter country code, area code and
phone number (without a zero in front of mobile
phone number) Press Send key to enter voice dial
to call out.
2. Dial a fixed line: “＋”country code +
entire
phone number + Send key.
Dial extension No. of a Fixed line
Some extension numbers of fixed line couldn’t be
dialed directly. You need to dial
telephone exchange first and then dial the extension
number. Type in a P symbol between telephone
exchange number and extension number, this
phone will dial the extension number automatically.
Follow below method to make a symbol P: short
press * key for twice times. Then it will display a P
symbol on screen.
Speed Dial
If you already set the speed dial numbers, then you
can long press number key 2 to 9 key to dial set
numbers out under standby mode. Long pressing
number key 1 is to dial to voice mailbox if you
already set the mailbox number.
14
Radio frequency (RF) exposure and SAR THIS
DEVICE MEETS INTERNATIONAL GUIDELINES
FOR EXPOSURE TO RADIO WAVES
Your mobile device is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the limits for exposure to radio frequency
(RF) recommended by international guidelines
(ICNIRP). These limits are part of comprehensive
guidelines and establish permitted levels of RF
energy for the general population. The guidelines
were developed by independent scientific
organizations through periodic and thorough
evaluation of scientific studies. The guidelines
include a substantial safety margin designed to
assure the safety of all persons, regardless of age
and health.
The exposure standard for mobile devices employs
a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit stated in
the international guidelines is 2.0 watts/kilogram
(W/kg)*. Tests for SAR are conducted using
standard operating positions with the device
transmitting at its highest certified well below the
maximum value. This is because the device is
designed to operate at multiple power levels
so as to use only the power required to reach the
network. In general, the closer you are to a base
15
station, the lower the power output of the device.
power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR of the device
while operating can be well below the maximum
value. This is because the device is designed to
operate at multiple power levels so as to use only
the power required to reach the network. In general,
the closer you are to a base station, the lower the
power output of the device.
SAR values may vary depending on national
reporting and testing requirements and the network
band. Use of device accessories and enhancements
may result in different SAR values.
The SAR limit for mobile devices used by the public
is 2.0 W/kg averaged over 10 grams of body tissue.
The guidelines incorporate a substantial margin of
safety to give additional protection for the public and
to account for any variations in measurements.
SAR values may vary depending on
national reporting requirements and the network
band.
The highest SAR value for this model phone tested
for use is 0.743 mW/g
Electric and electronic equipment and included
batteries contains materials, components and
substances that can be hazardous to your health
16
and the environment, if the waste material
(discarded electric and electronic equipment and
batteries) is not handled correctly.
Electric and electronic equipment and batteries is
marked with the crossed out trash can symbol, seen
below. This symbol signifies that electric
and electronic equipment and batteries should not
be disposed of with other household waste, but
should be disposed of separately.
As the end user it is important that you submit your
used batteries to the approriate and designated
facility. In this manner you make sure that the
batteries are recycled in accordance with legislature
and will not harm the environment.
All cities have established collection points, where
electric and electronic equipment and batteries can
either be submitted free of charge at recycling
stations and other collection sites, or be collected
from the households. Additional information is
available at the technical department of your city
17
ALL RIGHTS RESERVED
DENVER ELECTRONICS A/S
WWW.DENVER-ELECTRONICS.COM
Importer:
DENVER ELECTRONICS A/S
Stavneagervej 22
DK-8250 EGAA
DENMARK
Hereby, Inter Sales A/S, declares that this senior
mobile phone DENVER GSP-120 is in
compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC. A
copy of the Declaration of Conformity may be
obtained at
Inter Sales A/S, Stavneagervej 22, DK-8250 Egaa,
Danmark
Code for factory default:1234
Code for security password:1234
/
