Caution:
Before maintenance or cleaning is carried out, the
cooker hood should be disconnected from the mains
power supply. Ensure that the cooker hood is
switched o at the wall socket and the plug removed.
External surfaces are susceptible to scratches and
abrasions, so follow the cleaning instructions to ensure the best possible
result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out with the appliance cold
especially when cleaning. Avoid leaving alkaline or acid substances (lemon juice,
vinegar etc.) on the surfaces.
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life
expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning
fluid may be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent
any unsightly crisscross scratching patterns from appearing.
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth
is clean and well wrung before cleaning. Use a dry soft cloth to remove any
excess moisture left after cleaning.
Using neutral detergents and avoid using harsh cleaning chemicals, strong
appearance of the appliance and potentially remove any printing of artwork on
the control panel and will void the manufacturer's warrantee.
STAINLESS STEEL
CONTROL PANEL SURFACE
Important
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water
with a mild detergent and then brush it gently with a soft brush. Do not apply
too much pressure so as to avoid any damage to it . (Leave to dry naturally out
of direct sun light.)
Filters should be washed separately to crockery and kitchen utensils. It is
advisable not to use rinse aid.
MAINTENANCE AND CLEANING
12 13
GB
TROUBLESHOOTING
NOTE:
Any electrical repairs to this appliance must conform to your
laws. Contact the service centre if in any doubt before
undertaking any of the above. Always disconnect the unit from
the power source when opening the unit.
Light on, but motor
does not work
Fan switch turned o Select a fan switch position.
Fan switch failed Contact service center.
Motor failed Contact service center.
House fuses blown Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to
power outlet.
Switch power outlet on.
Light does not work,
motor does not work
One way valve and the outlet
are not tightly sealed Take down the one way valve
and seal with sealant.
Leakage from the connection
of chimney and cover Take chimney down and seal.
Oil leakage
Broken or faulty bulbs Replace blubs as per this
instruction.
Lights not working
The distance between the
cooker hood and the gas top
is too far
Refit the cooker hood to the
correct distance.
Insu cient suction
The fixing screw is not tight
enough
Tighten the hanging screw
and make it horizontal.
The cooker hood
inclines
Possible Cause Solution
Fault