Light on, but motor
does not work
Fan switch turned off Select a fan switch position.
Fan switch failed Contact service center.
Motor failed Contact service center.
House fuses blown Reset/Replace fuses.
Mains power cable is loose or
disconnected
Refit mains power cable to
power outlet.
Switch power outlet on.
Light does not work,
motor does not work
One-way valve and the outlet
are not tightly sealed
Take down the one-way valve
and seal with sealant.
Leakage from the connection
of chimney and cover
Take chimney down and seal.
Oil leakage
Broken or faulty bulbs Replace blubs as per this
instruction.
Lights not working
The distance between the cooker
hood and the gas top is too far
Refit the cooker hood to the
correct distance.
Insufficient suction
The fixing screw is not tight
enough
Tighten the hanging screw and
make it horizontal.
The cooker hood
inclines
NOTE: Any electrical repairs to this appliance must conform to your
laws. Contact the service centre if in any doubt before undertaking
any of the above. Always disconnect the unit from the power source
when opening the unit.
TROUBLESHOOTING
Possible Cause Solution
Fault
Caution:
• Before maintenance or cleaning is carried out, the cooker
hood should be disconnected from the mains power supply.
Ensure that the cooker hood is switched off at the wall socket
and the plug removed.
• External surfaces are susceptible to scratches and abrasions, so follow the cleaning
instructions to ensure the best possible result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out with the appliance cold especially
when cleaning. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on
the surfaces.
STAINLESS STEEL
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life
expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning fluid may
be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent any
unsightly crisscross scratching patterns from appearing.
CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is
clean and well wrung before cleaning. Use a dry soft cloth to remove any excess
moisture left after cleaning.
Important
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives, as this will affect the appearance of the
appliance and potentially remove any printing of artwork on the control panel and will
void the manufacturer's warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with a
mild detergent and then brush it gently with a soft brush. Do not apply too much
pressure so as to avoid any damage to it. (Leave to dry naturally out of direct sun light.)
Filters should be washed separately to crockery and kitchen utensils. It is advisable not
to use rinse aid.
MAINTENANCE AND CLEANING
GB
12 13
1. Insert the mains power plug into the socket.
2. Push switch ① to “ ”, the lamp will be on; push switch ① to “0”, the lamp will turn
off.
3. Push the switch ② into “I.II”, the motor will be on “low.high” two speeds, push into
“0”, the motor will turn off.
4. The power will be connected when you pull out the front panel. Conversely, pushing
back the front panel, the power will be automatically disconnected.
Start Using Your Cooker Hood
Rocker switch
Rocker switch
①
②