8
ENGLISH
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
As described in the section JABRA VOICE GUIDANCE above the
pairing process is supported by voice prompts.
1. Put the headset in pairing mode
- When you turn on your Jabra Talk 35 for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the LED is ashing blue.
2. Set your Bluetooth® phone to ‘discover’ the Jabra Talk 35
- Follow your phone’s instruction guide. First make sure that
Bluetooth® is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going
to a ‘setup,’ ‘connect’ or ‘Bluetooth®’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a Bluetooth® device.*
3. Your phone will nd the Jabra Talk 35
- Your phone will find the headset under name “Jabra Talk 35”.
Your phone then asks if you want to pair with the headset.
Accept by pressing ‘Yes’ or ‘OK’ on the phone and confirm with
the passkey or PIN = 0000 (4 zeros) . Your phone will confirm
when pairing is complete.
In case of unsuccessful pairing, put the Jabra Talk 35 into pairing
mode manually. Make sure the headset is on. Press and hold the
answer/end button for approximately 5 seconds until the LED is
ashing blue.
* Phone dependent