5
ENGLISH
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1. Put the headset in pairing mode
- When you turn on your Jabra Talk 5 for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the LED is constantly lit.
2. Set your phone to ‘discover’ the Jabra Talk 5
- Follow your phone’s instruction guide. First make sure that
Bluetooth® is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going
to a ‘setup’, ‘connect’ or ‘Bluetooth® ’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a device.*
3. Your phone will nd the Jabra Talk 5
- Your phone will nd the headset under name “Talk 5”. Your
phone then asks if you want to pair with the headset. Accept
by pressing ‘Yes’ or ‘OK’ on the phone and conrm with the
passkey or PIN = 0000 (4 zeros) if asked. Your phone will
conrm when pairing is complete.
Put the headset in pairing mode manually
In case of unsuccessful pairing, put the Jabra Talk 5 into pairing
mode manually. Make sure the headset is o. Press and hold the
answer/end button for approximately 5 seconds until the LED has
a constant light. The LED will ash before the light is constant –
keep holding down the button until light is constant. Then follow
the steps 2 and 3 above.
* Phone dependent