Caution:
Before maintenance or cleaning is carried out, the
cooker hood should be disconnected from the mains
power supply. Ensure that the cooker hood is
switched o at the wall socket and the plug removed.
External surfaces are susceptible to scratches and
abrasions, so follow the cleaning instructions to ensure the best possible
result is achieved without damage.
GENERAL
Cleaning and maintenance should be carried out with the appliance cold
especially when cleaning. Avoid leaving alkaline or acid substances (lemon juice,
vinegar etc.) on the surfaces.
The stainless steel must be cleaned regularly (e.g.weekly) to ensure a long life
expectancy. Dry with a clean soft cloth. A specialized stainless steel cleaning
fluid may be used.
NOTE:
Ensure that wiping is done along with the grain of the stainless steel to prevent
any unsightly crisscross scratching patterns from appearing.
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth
is clean and well wrung before cleaning. Use a dry soft cloth to remove any
excess moisture left after cleaning.
Using neutral detergents and avoid using harsh cleaning chemicals, strong
household detergents or products containing abrasives, as this will aect the
appearance of the appliance and potentially remove any printing of artwork on
the control panel and will void the manufacturer's warrantee.
STAINLESS STEEL
CONTROL PANEL SURFACE
Important
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water
with a mild detergent and then brush it gently with a soft brush. Do not apply
too much pressure so as to avoid any damage to it . (Leave to dry naturally out
of direct sun light.)
Filters should be washed separately to crockery and kitchen utensils. It is
advisable not to use rinse aid.
MAINTENANCE AND CLEANING
14 15
GB
NOTE:
• Make sure the filter is securely locked. Otherwise, it would loosen and cause
danger.
• When activated carbon filter attached, the suction power will be lowered.
INSTALLING GREASE MESH FILTERS
To install filters, following four steps .
- Angle the filter into the slots at the back of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon
filter should be changed every 3 to 6 months according to your cooking habits.
The installation procedure of activated carbon filter is as below.
1. Before installing or replacing the carbon filters, disconnect the mains power
to the unit.
2. Put the pin of the carbon filter into the rectangular hole of the fan (as per
the arrow A shown below).
3. Push the other side of the carbon filter toward the fan to make it flat (as per
the arrow B shown), and then press filter into fan.
4. If you want to remove the filter, press fastener of filter and remove it by
turning anticlockwise.