Warrior Products 832 paigaldusjuhend

Bränd
Warrior Products
Mudel
832
Tüüp
paigaldusjuhend
.
.
.
.
.
.
.
.
.
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Warrior, Inc.
ADVENTURE RACK
INSTALLATION INSTRUCTIONS
WAR 832
1. Assemble your Adventure Rack complete but do not tighten the bolts.
2. Measure the distance, on your tire carrier if you are installing the rack on your
carrier, between the upper mounting holes, and center this measurement, right to
left, on the tailgate. This should center your rack on the back of your vehicle. If
you have a flat surface on the back of your vehicle then you only need to center
your rack left to right and top to bottom. The lower bracket will bolt to the area
under the tailgate using self tapping screws.
3. Drill the upper mounting holes with a 3/8" drill bit on your swing away tire
carrier or your tailgate.
4. Align assembled rack to upper drilled holes, and position lower bracket under
tailgate. If you have a swing away tire carrier bracket extensions are available at
no cost by calling the factory at 888-220-6861. Mark holes and drill a 1/8" pilot
hole before you install the self tapping screws. Mount lower bracket with the
offset up.
5. Mount Adventure Rack to lower brackets so that you can mark holes to be
drilled in legs. Drill 4 holes on tailgate installation ( 2 on each leg); or 3 holes on
swing away ( 2 holes on right leg and 1 hole on left leg.
6. Install rack with supplied hardware.
7. Tighten the bolts and check to be sure the Adventure Rack is secure on the
rear of the vehicle. If you have bolted the rack only to your tailgate, a 50lb.
weight limit is advised. ENJOY YOUR NEW RACK!
Warrior, Inc.
11100 SW Industrial Way
Tualatin, Oregon 97062
(503) 691-8915
(503) 692-0364 FAX
(888) 220-6861 Toll Free
wp@warriorproducts.com
“Your Knight in Shining Armor!”
  • Page 1 1

Warrior Products 832 paigaldusjuhend

Bränd
Warrior Products
Mudel
832
Tüüp
paigaldusjuhend
Laadige alla PDF
aruanne

teistes keeltes

Muud dokumendid