ENGLISH
UNITED KINGDOM • Internet: www.clasohlson.co.uk
Ver. 20220426
Fabric Ceiling Light Art.no 36-8516 Model OCL-0970C FWH1
Please read the entire instruction manual before using the
product and then save it for future reference. We reserve
the right for any errors in text or images and any necessary
changes made to technical data. If you experience any
technical problems or have questions, please contact our
customer service team.
Responsible disposal
This symbol indicates that the product should not
be disposed of with general household waste.
This applies throughout the entire EU. In order to
prevent any harm to the environment or health
hazards caused by incorrect waste disposal, the
product must be handed in for recycling so that
the material can be disposed of in a responsible
manner. When recycling the product, take it to your local
collection facility or contact the place of purchase. They will
ensure that the product is disposed of in an environmentally
sound manner.
Safety
For indoor use only.
All light fittings must be installed in accordance with
current safety regulations to prevent life-threatening accidents.
Installation should only be performed by those with a good
knowledge of electrical wiring. If you are at all unsure about
proper installation procedures, seek the advice of someone
with the requisite knowledge to help you perform such an
installation or consult a certified electrician.
2. Fit the ribs onto the
rings as shown in the
diagram.
Installation
1. Warning: Before beginning any electrical
installation always disconnect the power
to the circuit you are working on, either by
turning off the main circuit breaker or by
removing the fuse from the consumer unit.
3. Feed the fabric all the way
down through the little ring.
4. Cover the ribs evenly with
the fabric and stretch it
taut using the drawstring.
Smooth out any wrinkles
by loosening the
drawstring, adjusting the
fabric and re-tightening
the drawstring.
5. Connect the input power cable to
the terminal block (lamp plug sold
separately).
11. Turn the power on.
Specifications
Rated voltage 220–240 V AC, 50 Hz
Light bulbs E14, max 3×10 W
(sold separately)
Diameter 55cm
6. Hang the ceiling light onto
the ceiling hook.
7. Screw on the bracket.
8. Screw three E14 light
bulbs into the sockets.
9. Push the light fitting onto
the bracket.
10. Adjust the nut to secure
the light fitting.