USER MANUAL
Operation Instructions
Constructed with aircraft-grade aluminum
LPE optics
Push/pull focus beam
Patented TackGrip rubber grip
High quality wrist lanyard
Tactical on/o button
IPX4 waterproof rating
Batteries included (4 AAA)
Features
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065
luxpro.com
866.553.8886
The LP630V3 has a Limited Lifetime Warranty Against Manufacturer’s
Defects from time of purchase.
For warranty claims please contact us by calling 801-553-8886 or
sending an email to info@simpleproducts.com
Product Warranty
High-Output Focusing
Handheld LED Flashlight
LP630V3
Low
High
ANSI/PLATO FL1 STANDARD
40 lm
630 lm
LUMENSMODES
20h 15m
2h 30m
RUN TIME
25m
265m
Medium 190 lm 8h 120m
BEAM
DISTANCE
Strobe 630 lm -- --
On/O: Press and release the button on the tail cap to turn the
light on and o.
Focus Head: To focus the light
beam, gently push the head away
from the light to extend it. Pull the
head back towards the light to
widen the beam.
Cycle Modes: Press button repeatedly to cycle through modes
(High/Medium/Ultra-Low). If light remains in a single mode for
longer than 3-5 seconds, the next press of the button will turn the
light o.
Light automatically resets to High mode when turned o.
Hidden Strobe On/O: Press and hold button for 3 seconds to
activate hidden strobe. Flashlight will remain in hidden strobe
mode until it is deactivated by pushing and holding the button
for 3 seconds again.
Battery Replacement
The LP630V3 uses 4 AAA batteries.
To replace the batteries, turn the tail cap counterclockwise to
remove it. Tip the light downward to slide out the battery case
which contains the batteries. Remove the batteries from the case
and insert new batteries matching the (+/-) symbols on the
batteries with the (+/-) symbols on the base of the battery case.
For best results, we recommend using brand new alkaline
batteries that are the same voltage and brand.
Re-insert battery case into ashlight with the metal knob and
arrow on the side of the battery case both pointing down.
Re-attach the tail cap by pressing down lightly and turning it
clockwise until tight
If you know it will be a while between uses, we suggest removing
the batteries from the ashlight and storing it in a dry, protected
place.
-
1
