Leht laaditakse ...
INSTEON Dimmer Switch
Quick Start Guide
INSTEON Dimmer Switch
Set ButtonHeat Sink Tab
(1000W Only)
O
Hold to Dim
On
Hold to
Brighten
Brightness
LEDs
Status LED
For the complete Owner’s Manual and
more, visit: insteon.com/support
Phillips Screwdriver
Tools Needed for Installation
Wire Cutter / Stripper
Voltage Detector
Flathead Screwdriver
Disconnect Power
Always disconnect power before
installation. Contact INSTEON
Support when uncertain about
installation.
1-866-243-8022
Installation
1
ON
ON
ON
ON
ON
ON
ON
OFF
ON ON
Turn o power to your switch at the
electrical service panel.
Circuit Breakers
Power is ON Power is OFF
Fuse Panel
or
2
Remove the old switch and disconnect
the wires. If your box lacks neutral wires,
stop and contact support.
Neutral
Wire
½”
12mm
1 2
!
3
Turn on power at the circuit breaker and
use a voltage detector or multi-meter
to identify line and load. Line will be
energized.
4
Turn o power at the circuit breaker. Connect the Dimmer Switch wires to the identied wires in
the junction box. Verify that the wire nuts are secure and that no exposed copper wire is visible
except for the bare ground wire.
Line
Load
Turn o power at the circuit breaker. Connect the Dimmer Switch wires to the identied wires in
the junction box. Verify that the wire nuts are secure and that no exposed copper wire is visible
except for the bare ground wire.
Neutral
Line
Load
Ground
5
Mount the Dimmer Switch into the
junction box with the LED bar on the left
and turn power on to the switch at the
circuit breaker panel.
6
Test your Dimmer Switch by tapping the
paddle to turn On and O. Press and
hold to dim or brighten.
Installation complete. You can now link
your Dimmer Switch to the Hub.
Follow the on-screen instructions to add
your Dimmer Switch to the INSTEON Hub.
Linking to the Hub
+
When prompted, press and hold the
Dimmer Switch’s set button.
If not using the Hub, refer to the
instructions that came with your product.
!
Dimmer Switch
Dim, brighten, set schedules and create
scenes for your Dimmer Switch using the
INSTEON Hub and App.
Device Control
RAW-1290 Rev 03.26.14
Protected under U.S. and foreign patents (see www.insteon.com/patents)
©2014 INSTEON
/