INSTEON 2477DH Kasutusjuhend

Tüüp
Kasutusjuhend
INSTEON Dimmer Switch
Quick Start Guide
INSTEON Dimmer Switch
Set ButtonHeat Sink Tab
(1000W Only)
O
Hold to Dim
On
Hold to
Brighten
Brightness
LEDs
Status LED
For the complete Owner’s Manual and
more, visit: insteon.com/support
Phillips Screwdriver
Tools Needed for Installation
Wire Cutter / Stripper
Voltage Detector
Flathead Screwdriver
Disconnect Power
Always disconnect power before
installation. Contact INSTEON
Support when uncertain about
installation.
1-866-243-8022
Installation
1
ON
ON
ON
ON
ON
ON
ON
OFF
ON ON
Turn o power to your switch at the
electrical service panel.
Circuit Breakers
Power is ON Power is OFF
Fuse Panel
or
2
Remove the old switch and disconnect
the wires. If your box lacks neutral wires,
stop and contact support.
Neutral
Wire
½”
12mm
1 2
!
3
Turn on power at the circuit breaker and
use a voltage detector or multi-meter
to identify line and load. Line will be
energized.
4
Turn o power at the circuit breaker. Connect the Dimmer Switch wires to the identied wires in
the junction box. Verify that the wire nuts are secure and that no exposed copper wire is visible
except for the bare ground wire.
Line
Load
Turn o power at the circuit breaker. Connect the Dimmer Switch wires to the identied wires in
the junction box. Verify that the wire nuts are secure and that no exposed copper wire is visible
except for the bare ground wire.
Neutral
Line
Load
Ground
5
Mount the Dimmer Switch into the
junction box with the LED bar on the left
and turn power on to the switch at the
circuit breaker panel.
6
Test your Dimmer Switch by tapping the
paddle to turn On and O. Press and
hold to dim or brighten.
Installation complete. You can now link
your Dimmer Switch to the Hub.
Follow the on-screen instructions to add
your Dimmer Switch to the INSTEON Hub.
Linking to the Hub
+
When prompted, press and hold the
Dimmer Switch’s set button.
If not using the Hub, refer to the
instructions that came with your product.
!
Dimmer Switch
Dim, brighten, set schedules and create
scenes for your Dimmer Switch using the
INSTEON Hub and App.
Device Control
RAW-1290 Rev 03.26.14
Protected under U.S. and foreign patents (see www.insteon.com/patents)
©2014 INSTEON
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

INSTEON 2477DH Kasutusjuhend

Tüüp
Kasutusjuhend

teistes keeltes