10 11
EN
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363 fitted to the mains
lead. If the plug is unsuitable for your socket outlets or needs to be replaced, please
note the following. If the plug is a non-rewireable one, cut it from the mains lead
and immediately dispose of it. Never insert it into a socket outlet as there is a very
great risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be done according to the
following instructions:
Important: The wires in this mains lead are coloured in accordance with the
following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your
plug, proceed as follows:
⋅the wire which is coloured blue must be connected to the terminal which is
marked with the letter N or coloured black,
⋅the wire which is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.
Do not connect any wire to the terminal which is marked with the letter E or by the
earth symbol , or coloured green or green and yellow.
▪ If a 13 A (BS 1363) plug is used it must be fitted with a 3 A fuse conforming to BS
1362 and be ASTA approved. If any other type of plug is used, the appliance must be
protected by a 5 A fuse either in the plug or adapter or at the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
The appliance complies with European directives 2014/35/EU,
2014/30/EU and 2009/125/EU.
The conformity according to EN60335 clause 11 was verified by
using the following recipe: 150 g carrott + 300 g water
Operation: 15 s; Speed: max
At the end of its life, this product may not be disposed of in
normal household waste, but must instead be taken to a collection
point for recycling electrical and electronic appliances.
The materials are recyclable in accordance with their labelling.
Reuse, recycling and other ways of reutilising old appliances make
an important contribution to protecting our environment.
Please ask your local authorities for information about the
appropriate disposal point.
End users are personally responsible for deleting any personal data
that may be stored on appliances they are disposing of.
Subject to change.
Prepare the desired food and fill a sufficiently high and stable receptacle with the food.
Make sure that the device is disconnected from the power supply.
Insert the purée rod (4) into the bottom of the coupling on the drive unit (3). Click the
purée rod (4) into place. The purée rod (4) must be fitted securely onto the appliance
and must not feel loose or fall off. Use the control dial (1) on the top of the appliance
to select the required speed.
You can also change the speed during operation. Keep the purée rod (4) in the food.
Caution: There may be a slight spray during operation. To avoid spray,
the lower end of the purée rod (4) with the blades should always be
completely covered. Keep the appliance slightly angled when prepar-
ing liquid foods in order for the contents to mix better. If you are
preparing hot food, make sure you do not hold the appliance in the
steam so as to avoid condensation on the drive unit (3). You can use
a small clean cloth to protect the drive unit (3) and your hands from
the hot steam. Immediately wipe off any condensation that forms on
the casing. Now you can insert the mains plug into the socket. Hold the container with
one hand and press the start button (2). The motor starts up. As soon as your food has
reached the desired consistency, release the start button (2). The appliance is designed
to be used for short periods of time. After operating it for 90 seconds, take a break to
allow the appliance to cool down to room temperature. Wait for the motor and purée
rod (4) to come to a standstill and then remove the rod from the mixing bowl. Always
pull the mains plug out of the socket before you clean the appliance.
Cleaning and maintenance
Remove the power plug immediately after use.
Clean the purée rod (4) immediately after every use. To pre-clean the purée rod (4), just
move it quickly from side to side for a short while in a container filled with hot water.
Then, for best results, remove the purée rod (4) from the drive unit (3) for further
cleaning.
The drive unit (3) must not be cleaned in a dishwasher.
The drive unit (3) should never be placed in water, only wiped down on the outside
with a damp cloth. Do not use any abrasive cleaning agents.
Dishwasher safe Can be rinsed
under running
water
Wipe with a
damp cloth
Drive unit (3)
Purée rod (4)
max.