LED Indicator Live Wire(input)
Output
Neutral Wire(input)
Touch switch is an in-wall switchgear based on Z-Wave wireless radio frequency technology
for intelligent control. This product can be added to the gateway or PC controller
output.
-20℃~60℃
-10℃~45℃
Z-Wave
Below blue wire is neutral wire (N).The red wire is live (L)
the touch switch.
0
load change.
0
- Send Switch binary report.
0
devices directly. Group 1 is lifeline service that assigned to touch switch status. It enables
(1) Power on the switch.
(1) Connect the power supply.
wires of touch switch.
2) Screw on the screws.
3) Connect household loads to the L1 of touch switch.
Trigger
Power on
Short press
once
Long press
1-5 seconds
Long press
5-10 seconds
this procedure will reset Touch Switch to factory default.
than 20 seconds
Trigger
Short press
LED status
5
1. Switch Binary Report
Group 1
5
Group 2
NL L1 L2
NL L1 L2
NL L1 L2
N
LL1
Single Touch Light Switch
KP-SW-07