12
INSTRUCTION MANUAL · DRY CONNECTED
EN
Do not install the unit in places where inflammable gas may leak
Operate the unit in temperature between 5°C and 35°C.
Do not use outdoors. It is intended for indoor residential applications only.
Do not operate near walls, curtains or other objects that may block inlet and outlet.
Keep the air inlet/outlet free of obstacles.
If tipped more than 45°, allow the unit to stand in upright position at least 24 hours before
starting up.
Close all doors, windows, and other outside openings of the room to improve the working
effect.
Avoid direct sunlight.
It is normal for the air outlet to feel warm after continuous usage on hot days.
Empty the water tank before moving the device.
Make sure the water tank is correctly placed, otherwise it will not operate properly.
The unit starts up in the mode selected when the unit was last used.
The unit starts dehumidifying if the room humidity is 3% higher than the selected humidity.
There is a protective 3-minute delay of the compressor. Wait 3 minutes for the dehumidifier
to resume dehumidifica ion.
FUNCTIONS
POWER BUTTON
Press this button to switch the unit on. The indicator lights light up, the default fan speed is
high and default humidity is 50%.
When the unit is on, press the power button to switch the unit off. The indicator lights shuts
off, and the compressor stops immediately, and then the fan shut down after 30 second
delay.
MODE BUTTON
Press this button to switch between auto, laundry, and sleep mode.
AUTO
When the environmental humidity is the same or over your chosen humidity +3%, the fan
starts working, and the compressor starts working after 3 seconds.
When the environmental humidity is the same or lower than your chosen humidity -3%, the
compressor stops, and the fan stops after 30 second delay.
Press Set% button to adjust the humidity level in auto mode.
LAUNDRY DRYING MODE
The compressor keeps working without control by humidity; fan speed can be adjusted,
but target humidity can not be adjusted.