POINT POAP4010 LUFTRENSER Kasutusjuhend

Air Puriﬁer

POAP4010

User Manual

2

GB

Thank you for purchasing your new POINT Air Purifier. We recommend that you spend some time reading this

instruction manual in order to fully understand all the operational features it offers.

Read all the safety instructions carefully before use and keep this instruction manual for future reference.

NO

Takk for at du kjøpte din nye luftrenser fra POINT. Vi anbefaler at du tar deg tid til å lese gjennom

helebruksanvisningen for å forstå fullt ut alle funksjonene som tilbys.

Les alle sikkerhetsanvisningene nøye før bruk, og oppbevar bruksanvisningen for fremtidig referanse.

FI

Kiitos, kun valitsit uuden POINT-ilmanpuhdistimen. Suosittelemme, että käytät aikaa tämän

käyttöoppaanlukemiseen, jotta ymmärrät täysin, mitä toiminnallisia ominaisuuksia tuote tarjoaa.

Lue kaikki turvallisuusohjeet huolellisesti ennen laitteen käyttöä ja säilytä käyttöopas myöhempää käyttöä

varten.

DK

Tak fordi du har købt din nye luftrenser fra POINT. Vi anbefaler at du læser denne brugsanvisning, så du får

enfuld forståelse af hvordan alle betjeningsfunktionerne virker.

Læs alle sikkerhedsinstruktioner nøje før brug, og behold denne brugsanvisning til senere reference.

SE

Tack för att du har köpt din nya luftrenare från POINT. Vi rekommenderar dig att du tar din tid att läsa

igenomdenna bruksanvisning för att till fullo förstå alla funktioner.

Läs noga igenom alla säkerhetsinstruktioner före användning och spara bruksanvisningen för framtida bruk.

3

Instruction manual - English Page 4 - 18

Bruksanvisning - Norsk Side 19 - 33

Ohjekirja - Suomi Sivut 34 - 48

Brugervejledning - Dansk Side 49 - 63

Bruksanvisning - Svenska Sido 64 - 78

GBNO

FI

DK

SE

6

Attention

The pictures contained in this Manual are for reference only. Your physical product may vary slightly from the pictures.

Component name

12

Air outlet grille

Operation panel Display screen

Air inlet grille Pre-Filter HEPA Filter

Host

Manual

Protective bag

12

Product Instruction

7

GB

Installation steps

1 Remove the air inlet grille. 2 Taking out the Pre-Filter

Press down and pull the U-shaped snap joint, then

take out the Pre-Filter.

3 Taking out the HEPA filter

Hold both sides of the HEPA filter with both hands,

then take it out.

4 Remove the protective film from the filter assembly.

Installation Instructions

8

5 Install the HEPA filter. 6 Installing the Pre-Filter

Align the slot position at the bottom, and then click

into the upper U-shaped snap joint.

7 Installing the air inlet grille

Align the slot position at the bottom, then press both

sides of the upper part of the air inlet grille, and then

buckle up the air inlet grille.

8 Plug in the mains power plug into a mains power

socket.

9

GB

1 Control panel

Light sensing

function

CHILD LOCK

(Long press 3s)

AUTO MODETIMER

(Long press 3s to

reset the ﬁlter)

SLEEP MODESPEED ON/STANDBY

Child lock

Long press the

child lock for 3s

Timing button

Optional 1/2/4/8h

timing

On/standby button

The wind speed

buttons have low,

medium and high

wind.

Automatic mode

Adjusts the wind speed

automatically according

to the air quality.

Sleep mode

If PM2.5>50, make the wind slightly

larger to ensure puriﬁcation eect;

If PM2.5<50, keep it in the mode of

extremely low noise.

Instructions

10

2 Display panel

ÿÿ

PM2.5 numerical display

Timing function prompt

HEPA filter replacement prompt

Child lock prompt

Sleep mode prompt

Automatic mode prompt

Air quality indicator light

Air quality Excellent;

Blue

Green

Orange

Red

Air quality Good;

Air quality Medium;

Air quality Poor;

11

GB

3 Test Run

Attention

Ţ This appliance cannot be started normally until all air inlet grilles are installed correctly.

Ţ When this appliance is in standby mode, restart it, it will return to last working mode.

Ţ After an unexpected power outage such as if the mains plug was removed during use, the appliance will return to

the working mode it was in prior to the outage.

1 Preparation

Power on for the first time, the display panel will flash

for 1s, and then the screen will turn off. The appliance

is now in standby mode.

2 Remove the protective film of the filter assembly.

Flash for 1s

12

3 Install the filter. 4 On/standby

Press the on/standby button.

On/standby

5 Warm up

When the particulate matter sensor enters the warm-

up state, PM2.5 numerical display shows "---", and is

normal after 10s.

6 Work

The purifier is powered on for the first time and then

enters automatic mode.

13

GB

Body cleaning

Attention

Ţ Be sure to turn off before any maintenance, and remove the mains power plug from the mains power socket.

Host

Wipe the body with a soft towel.

Air inlet grille

Open the air inlet grille and vacuum up dust with a vacuum cleaner or wipe it

with a cloth.

Air outlet grille

Remove the air outlet grille and vacuum up dust with a vacuum cleaner or wipe it with a cloth.

Cleaning and Maintenance

14

Ţ It is recommended to clean the Pre-Filter at least once every two weeks.

The cleaning cycle can be based on the usage environment and time, the more polluted the environment then it

should be cleaned more frequently.

1 Unplug the appliance, and take out the Pre-Filter. 2 Vacuum up the dust or wipe it with a cloth.

3 If there is a lot of dirt, first soak in a diluted common

kitchen detergent and then do the cleaning.

4 Dry the Pre-Filter.

Soaking time is

about 10min.

Cleaning of Pre-Filter

15

GB

5 Assemble the Pre-Filter and the Air inlet grille. 6 Plug in the appliance, and turn on.

16

1 Filter model:

FC-35S1A (include 1)

2 When the ﬁlter replacement light is on, this reminds

you that the HEPA ﬁlter should be replaced.

If it is not replaced in time, the prompt will appear

every startup.

3 Replace a new ﬁlter 4 Long press timing button for 3s, reset the HEPA ﬁlter.

Long press for 3s

Replacement of the ﬁlter components

17

GB

Service Guide

Faults Handling

Before inviting someone to inspect or repair, please check the following items.

Error code Error description Handling method

Disassembly protection reminder Properly installed inlet grille

Sensor failure Contact the after-sales

Abnormal fan speed Contact the after-sales

18

SPECIFICATION:

This symbol on the product or in the instructions means that your electrical and electronic

equipment should be disposed at the end of its life separately from your household waste.

There are separate collection systems for recycling in the EU.

For more information, please contact the local authority or your retailer where you purchased

Imported and Exclusively marketed by:

Power International AS,

PO Box 523, N-1471 Lørenskog, Norway

Power Norge:

https://www.power.no/kundeservice/

T: 21 00 40 00

Expert Danmark:

https://www.expert.dk/kundeservice/

T: 70 70 17 07

Power Danmark:

https://www.power.dk/kundeservice/

T: 70 33 80 80

the product.

Model: PO112CFN

Rated power: 50W

GB

Rated voltage: 220-240V~ 50Hz

Punkt 1 Danmark:

https://www.punkt1.dk/kundeservice/

T: 70 70 17 07

Expert Finland:

https://www.expert.ﬁ/tuki/asiakaspalvelu/

T: 020 7100 670

Power Finland:

https://www.power.ﬁ/tuki/asiakaspalvelu/

T: 0305 0305

Power Sverige:

https://www.power.se/kundservice/

T: 08 517 66 000

11

Leht laadib ...

POINT POAP4010 LUFTRENSER Kasutusjuhend

POINT POAP4010 LUFTRENSER Kasutusjuhend

teistes keeltes

Seotud paberid

Muud dokumendid