8
* There may be differences between the graphic and the actual
product
PREPARATION
• Before starting work, check the environment you will be working in
thoroughly and remove all objects that can be drawn in or rejected
by the hoover's air blast.
USE OF
Read the detailed instructions before using this device, especially the
battery, charger and accessories.
Do not handle this appliance with wet hands to prevent electric shock.
Ensure that the battery socket and charger are always dry to prevent any
electrical shock.
Do not charge the battery in a damp or wet location. Do not use, store or
charge it where the temperature is below 50°F (10°C) or above 100°F
(38°C). Do not store the battery outdoors or in vehicles.
Remove the battery from the unit when not in use and before any
servicing.
When the battery is not in use, keep it away from other metal objects such
as paper clips, coins, keys, nails, screws or other small metal objects that
can short-circuit the terminals. Short-circuiting the battery terminals can
cause sparks, burns or fire.
Do not use a damaged or modified battery.
Do not overturn or rotate the unit, as dust and liquids can enter the internal
structure through the air intake.
Any damaged parts should be replaced or repaired by authorised service
and qualified technicians.
Keep hair, loose clothing, fingers and all body parts away from the
openings and moving parts of the hoover.
Do not use the unit to collect hot water/liquid, flammable objects or
flammable liquids (e.g. cigarettes, matches, explosives or burning items,
embers of ashes).
Pay attention to the maximum length that the flexible hose can reach.
Maintain the correct position and balance at all times when operating the
machine.
Never vacuum dry dust and debris without a HEPA filter fitted.
• Remember to clean the tank, filter, flexible hose and accessories
after use. If the unit is not working or there are any technical
problems, please contact your local shops, or call our customer
service hotline for assistance
• Always work wearing long trousers and sturdy footwear.
• Work only in daylight or under very good artificial lighting.
• Always make sure your feet are standing firmly. On sloping surfaces,
work carefully to avoid losing your balance.
• Do not undertake work without the hose accessories and working
tips fitted.
• Ensure that the ventilation openings in the housing are free of debris.
• Do not make the hoover available for use by children or anyone who
has not read these instructions.
• Refrain from further work if there are bystanders, children or animals
in the immediate vicinity
• Do not direct debris from air blasts and leaves towards people.
• Hold the hoover securely while working, keep a stable position while
working.
MAINTENANCE AND STORAGE
• Keep all components in good condition to be sure that your garden
tool guarantees safe operation.
• Replace worn or damaged parts to maintain safety.
• Keep out of the reach of children.
ATTENTION! Despite the inherently safe design, the use of safety
measures and additional protective measures, there is always a risk
of residual injury during operation.
WARNING! Do not use the unit for any purpose other than its
intended use.
EQUIPMENT AND ACCESSORIES
1. Flexible hose 1 pc.
2. HEPA filter 1 pc.
3. Sponge fltr - 1 pc.
4. Working tips - 2 pcs.
5. Flexible adapter - 1 pc.
6. Transport castors - 4 units.
7. Rigid folding tube 3 elements.
PREPARATION FOR WORK
FITTING CASTORS, BASE
Attach the castors fig. B1 to the base fig. B2 by pushing them into the
holes in the base. Then place the running base with castors fig. B3 on the
upside-down dust container fig. A10 and press it firmly onto the container
until the latches fig. B4 are in place. The running base fig. B3 is secured
against falling out of the dust container with the latches. To remove it,
press the buttons on the base fig. B4 and remove the chassis from the
dust container.
INSTALLATION OF HOOVER
The flexible hose and accessories should be correctly and firmly
connected before operating the appliance.
Install the end of the flexible hose as shown in Fig. A3 in the hole as
shown in Fig. A9. After inserting the hose into the hole, fig. C1, turn it
clockwise as far as it will go (in clockwise direction), fig. C2.
After assembling the rigid tube fig. C4, place it in the tube holder fig. C3,
then mount the selected working tool to the tube fig. C5.
INSTALLATION OF HEPA FILTER
To install the HEPA (accordion) filter, remove the top part from the hoover
fig. A16. Then turn it over so that its underside is visible, insert the HEPA
filter into the round opening fig. D1 and secure it by turning it clockwise
(clockwise) fig. D2. Then place the upper part of the hoover on the tank
and secure it with the latches fig. D4.
FITTING A RUBBISH BAG
To fit the waste bag, remove the top of the bag from the hoover fig. A16.
Then slide the bag onto the receptacle fig. D3 so that the elastic seal of
the bag is between the grooves positioning it. Then place the upper part
of the hoover on the container and secure it with the latches fig. D4
BATTERY INSTALLATION
Lift the battery cover fig. D5 and connect the battery to the socket fig.
E2. Then lower the battery cover fig. E3.
NOTE: The battery cover must be closed during operation. Press the
switch to the ' I ' position to start the unit fig. E4.
Press the switch to the ' 0 ' position to stop the unit.
The hoover is ready for use.
HOOVER WORK
RETRACTION/SUCTION FUNCTION
• If the flexible hose is connected to the Figure A9 socket, the hoover
will draw waste or liquids into the tank or bag.
• Connect the dedicated working nozzle with the rigid pipe for the
specific job Fig. A12/A15. Then start the hoover and get to work.
BLOWER FUNCTION
• Connect the hose connector to the air outlet Fig. A7.
• Turn the connector clockwise to lock.
• The hoover then works in blower mode. It can be used to get rid of
leaves, sand from the terrace, grass cuttings from the pavement,
snow from the windowsill, etc.
DRY VACUUMING
When working, make sure that the waste collected is not too large.
So that they do not get caught in the hose or accessories. Make sure
the flexible hose and accessories are correctly connected and the
HEPA filter is correctly installed to avoid leakage when working wet.
• The following substances must not be collected:
• Flammable liquids (paraffin, petrol, solvents, etc.).
• Hot substances that are burned-or smoking (cigarettes, matches,
incense sticks, hot ashes or embers from a fireplace), sparks and
metal dust generated when cutting or grinding metal, etc.
• Flammable materials (toner, paint, spray, etc.).
• Foams as a carpet cleaner, etc. (they can cause an explosion or fire)
• Explosive or pyrophoric substances (nitroglycerine, aluminium,
magnesium, titanium, zinc, red phosphorus, yellow phosphorus,
celluloid, etc.).
• Sharp objects (glass, cutlery, wood splinters, metal, stone, nails,
razor blades, replacement blades, pins, pins, etc.).
• Fine flint and conductive
• Powdered metal or carbon powder
• It should not be used as a dehumidifier
• Large quantities of dust such as (flour, fire extinguisher powder, etc.).
• Substances that cause toxic symptoms
• Aggressive chemicals (acid, bleach, etc.)
• Liquid or moist litter, containing vomit, faeces
• Asbestos
• Pesticides
• Static shock on the surface of the unit may occur when vacuuming
fine dirt in low humidity areas. Please use protective insulating gloves
or spray water from the humidifier to increase the humidity of the air