Thermo AOPS7433 Omaniku manuaal

OPTIONAL TIMER KIT AOPS7433

MO-431

ECN 5507-MA 171201

Installation of Solid State Timer to Oil Furnace TIMER - TP Part No. 350506

1) Turn power off to furnace.

2) Mount timer just above 4 X 4 junction box (within 5”) on side casing of furnace. Use mounting

screw provided.

3) Open junction box and connect 3 short wires as shown on wiring diagram.

4) Connect long black wire to primary control located on junction box on oil burner.

Note: Burner Polarity must be correct.

5) Adjust timer to recommended settings. DOM (sec) 72

DOB (min) 4.0

NOTE: DOM value = Set the arrow on the dial between the 7

and 8

tick mark on t1. This time

should be approximately 72 seconds (+8/-16 seconds)

DOB value = Set the arrow on the dial between the 5

and 6

tick mark on t2. This time

should be approximately 4 minutes (±15 seconds)

Confirm timings are set as desired prior to leaving furnace with a stopwatch.

6) Re-establish power and check furnace operation.

WIRING DIAGRAM

ELECTRICAL SCHEMATIC

Laadige alla PDF