A. Motion Sensor
B. Daylight sensor
1. Turn on the light and dimming to a comfortable brightness, the daylight sensor will memory this lux value which performance on
desk as a standard lux.
2. When ambient brightness increase (reduce), light will adjust to reduce (increase) its brightness, and guarantee the lux on desk are
same to that standard lux, or at least close to that standard lux, it may have around 10% tolerance.
3. When every time dimming again on light brightness, daylight sensor will memory this new lux value which performance on desk as
a new standard lux.
Attention: The lux value which the light performance on desk will be effected if there is any change on desk within the area of 20° angle
under the daylight sensor.
Detectable area Here to tell you how to play Motion Sensor & Daylight Sensor
1.Turn on the lamp. 2. The lamp brightness reduce
to 30% when there is no
presence in 30min.
3. After another 30min, the lamp
switches off automatically when
still no presence detected.
4. The lamp will switches on
autocmetically at once when
there is presence detected.
Adjust the dip switch to the module by screwdriver.
Short press to turn on/off the indirect light
Long press to dimming
On/Off Switch:
ON: Turn on and will keep light same as previous status automatically
OFF: Turn off the light
Long press for CCT change (only for color dimming)
Short press to turn on/off the indirect light
Long press to dimming
non color dimming color dimming