111612 01
FIRE CRACKLE SOUND
GENERATOR - CF6-A1
OPERATING INSTRUCTIONS
Kit Includes:
• 1 Fire Crackle Sound Generator Box • 1 Instruction Sheet
The fire crackle sound generator is designed to generate sounds
similar to a real wood burning fire. This sound generator may be
used with a vent-free or vented gas heating system. The fire crackle
may be placed under a firebox with the control knobs of a fireplace,
or outside of a firebox or heater in an area where temperatures are
not too hot. Excessive temperatures may damage fire crackle sound
generator.
INSTALLING BATTERIES
1. Slide open battery cover panel on rear of sound generator (see
Figure 1).
2. Install three (3) AA alkaline batteries (not included) as shown
in Figure 1.
3. Replace battery cover panel.
Figure 1 - Battery Install and Volume Control
Fire Crackle
Sound Generator
Volume Control
Switch
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY 42102-9004
NOT A UPC
111612-01
Rev. A
04/03
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Battery Cover
Panel
Figure 2 - On/Off Switch
Fire Crackle
Sound Box
On/Off
Toggle
Switch
Dimple
OPERATING FIRE CRACKLE SOUND
GENERATOR
Turning On and Off
1. To turn sound generator on, toggle red switch on side of box
so dimple side is flat against side of box. See Figure 2.
2. To turn sound generator off, toggle side of switch without
dimple flat against side of box.
Adjusting Volume
Move switch on rear of sound generator to LOW, MED, or HIGH
for desired sound level. See Figure 1.
(3) AA Alkaline
Batteries (not
included)