Power On? Confirm that the power light is green on the front of your ADB set top box (box with clock on
the front). If it is red push the “STB” button and then the Power button on the ADB remote. The red light
means that the set top box is turned off; the green light indicates it is on.
If your TV loses sound, picture, or freezes press the “Reset” button on the front of the set top box to the
left of the clock. If you have a DVR (Digital Video Recorder), unplug the power (black cord) from the back
for a few seconds and then plug it back in. The DVR box does not have a reset button on the front. This
will reboot the box and will allow it to reload all settings. This process can take three or four minutes and
when complete your TV will come back on to Channel 1. At this point you can go back to what you were
watching.
-If your TV is on the wrong Input or Channel, you may not have picture or sound. Should this happen,
check to make sure your TV is on channel 3 if hooked up with a coax cable. You can use your regular TV
remote or press the “TV” button on the ADB remote and type 03 on the keypad to get the TV back on
Channel 3. This also happens when your TV is on the wrong Input for A/V inputs. To check the inputs
you can use your regular TV remote or press the “TV” button on the ADB remote, and at the bottom of
the ADB remote on the left side press the “TV/Video Input” button. This button will switch between
inputs on your TV. Once you are on the correct Input your picture and sound should return. After your
TV is back on the correct channel or Input, press the “STB button” to put the set top box back in control.