Installation Instructions

Procedure:

1. Set the parking brake on vehicle and jack up the front end. Install jack stands under the jack pads on your

vehicle.

2. remove front a-arm pivot bolts and install the front portion of the lower stressbar with the center portion

hanging on the low side. Reinstall the pivot bolts with red loctite and torque to 43ft/lbs.

3. lock center nut in place on stressbar.

4. Install rearward portion of the stressbar removing the “U” shaped clamps. Then put the rear portion of

the bar into place and tighten the bolts to 22ft/lbs. Tighten the locknuts on the bar.