Kenwood KBP-5 paigaldusjuhend

INSTALLING/ REMOVING ALKALINE BATTERIES

(KENWOOD KBP-5 OPTIONAL BATTERY CASE)

WARNING

●Do not install batteries in a hazardous environment where sparks

could cause an explosion.

●Never discard batteries in fire; extremely high temperatures can

cause batteries to explode.

●Do not short circuit the battery case terminals.

●Do not use rechargeable batteries.

Note:

●If you do not plan to use the transceiver for a long period, remove the

batteries from the battery case.

●This battery case has been designed for transmitting at a power of

approximately 1 W (the low power setting on your transceiver). If you

want to transmit a stronger signal (using the high power setting on

your transceiver), use an optional rechargeable battery pack.

1To open the battery case, press

on the two tabs on the upper rear

of the case, then pull the two

halves apart.

2Insert 6 AA (LR6) Alkaline batteries

into the battery case.

●Be sure to match the polarities with

those marked in the bottom of the

battery case.

3Align the tabs of the cover with

the base, then push down on the

cover until it locks in place.

Laadige alla PDF