Digi-Code Coding Instruc�ons
Both Digi-Code and Mu-Code are electronically the same.
MULTI-CODE Switches: UP for ON
DIGI-CODE Switches: DOWN for ON
1. Open both the working original remote and the new remote to reveal
two x 10 switch banks (L/H Bank = L/H Buon the circuit board or
one bank of 10 switches for a single buon remote.
2. Copy the switches exactly when coding Mu-Code to Mu-Code or
upside down when coding Mu-Code to Digi-Code.
If no working remote is available look to the receivers on the motor/s (these
are generally grey rectangular boxes aached to the motor.
Remove the inspecon panels to reveal the 10 switches. This will mainly be a
Mu-code receiver. Follow the steps above once you have located the
switches on the receiver.
www.remotepro.com.au
-
1
