The remote uses 2 x AAA batteries.
They should be removed prior to disposal.
Operating instructions
Remote control sockets - 3 pack
Model: 67443
Directions for use
The remote is supplied with 2 x AAA batteries - before rst use remove the battery tab from the battery compartment.
1. Plug a socket into the mains and switch on, the button on the top of the socket will ash red.
2. Within 30 seconds choose a channel (A,B,C or D) on the remote and press the corresponding ON button, you will hear the
relay in the socket click and the button will stop ashing red.
3. Plug your appliance into the socket and use the selected channel ON/OFF button to operate.
4. Repeat the above process on the remaining sockets.
5. All sockets can be turned on and off simultaneously using the ALL ON/OFF buttons on the remote control.
6. The sockets can also be turned on and off manually by pressing the button on the top of the socket.
How to clear the channels and reset a socket
1. Turn the power off and on at the mains (the button on the top of the socket will ash red).
2. Press and hold the ALL OFF button on the remote (the red ashing will become quicker).
3. When the button stops ashing all channels are clear and the socket is reset.
Battery replacement - remote
1. On the back of the remote slide the battery cover down and lift to remove.
2. Insert 2 x AAA batteries, observing the polarity markings.
3. Ret the battery cover.
Uni-Com (Global) Ltd.
1 & 2 Enterprise Way,
Edenbridge, Kent, TN8 6EW
+44 (0)1732 865238
www.uni-com.co.uk
V2
Made in China
Authorised Representative
Zatisfy AB
Storgatan 51
90326 Umeå
Sweden
+46 (0)70–5790027
Safety warning
Keep out of reach of children. For indoor use only. Do not plug in an appliance where the load exceeds 13A. Always
ensure the plug of any appliance is fully inserted into the socket. Do not use if the casing of the socket becomes
cracked or damaged. Remove the batteries if the remote control is not going to be used for an extended period.
Do not mix new and used batteries. Do not mix different types of batteries. Exhausted batteries should be removed
immediately. Failure to follow these instructions could result in re, electric shock, injury or damage to persons, product
or property and will invalidate the guarantee.
Specication
240V AC 50Hz
Max load: 13A
Frequency: 433.92MHz
Guarantee
This product is guaranteed for one year from the date of purchase against faulty parts or workmanship. It does not cover
batteries or physical damage to the units. Proof of purchase required. This does not affect your statutory rights.
Batteries
Hereby, Uni-Com (Global) Ltd declares that the radio equipment type door chime is in compliance with the Radio
Equipment Regulations 2017 (SI 2017/1206) and Directive 2014/53/EU. The full text of the UKCA Declaration of
Conformity is available to view at www.uni-com.co.uk.