CMP Del Ozone Spa Check Valve Omaniku manuaal

Check Valve Replacement Kit Instructions

Check Valve Removal

1. Locate the rst check valve coming out of the cell. Cut the cable tie and

remove this check valve.

2. Cut the cable tie on the venturi injector.

3. Using a pair of wire cutters/ dykes, pry up the tubing on the injector

and remove it.

4. Cut the cable tie on check valve going into the ozone cell. Remove and

replace with new one.

New Check Valve Installation

1. After removing the tubing on the injector, hold injector in hand and slide

¼” tubing over injector barb.

2. Insert rst check valve into the tubing coming from the ozone cell and

install the two cable ties where needed.