#NK36-B501 LOG SET
For use with model #NDK-36-DV
WARNING: This product can expose you to chemicals including ceramic ber and/or silica dust which is (are) known to the State of California
to cause cancer, birth defects, or other reproducve harm. For more informaon, visit www.P65Warnings.ca.gov
• If converng to propane, complete the conversion before installing the log set. Follow the conversion instrucons included
with the kit.
• If installing a panel set, complete installaon of panel set before log installaon
• Install all light bulbs into the front and rear ember bed light kits before log installaon.
1. Remove valance from replace.
2. Place log #N36-B1 and log #N36-B2 on corresponding pins on burner (not shown). Logs must lie at on media tray. Failure to do
so will negavely aect the ame
3. Place log #N36-B3 on the corresponding pin on top of #N36-B2. Rotate the opposite end of #N36-3 towards the back of the
replace.
4. Place log #N36-B4 on the corresponding pin on top of #N36-B3. The other end of the #N36-B4 log will lay on the log plate locat-
ed in the rear center of the replace.
5. Fill back media tray with crushed glass media.
6. Place log # N36-B5 so the le side of the log aligns on the pin on top of #N36-B1. Place the right side of the log on the exposed
pin on log #N36-B4.
Rev. 1
NOTE: Log numbers are located on the boom or side of each log. Refer to the following instrucons and illustraon for proper
placement. Your components may look dierent than the ones shown.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may aect ame appearance and may cause
excessive soot to build upon the glass.
#NK36-B501 LOG SET
For use with model #NDK-36-DV
Rev. 1
#NK36-B501 LOG SET
For use with model #NDK-36-DV
Rev. 1
7. Install the crushed media on the ember-
bed and lava rock along the sides of the
emberbed.
8. Place log #N36-B6 on the le burner
assembly by aligning the pins on the
burner and the holes in the boom of
the log. Repeat with log #N36-B7 for the
right burner assembly.
9. Place log #N36-B8 around the center log
rack as shown.
10. Place (3) small size klinkers on the rear
burner. Ensure that none of the klinkers
cover burner ports on this burner. The
klinkers should be pushed back against
the back ange of this burner.
11. Place #N36-B9 and #N36-B10 on the
sides of the lava rock.
12. Use a s or steel bristle brush to dis-
tribute rockwool embers onto the burn-
ers and logs.
-
1
-
2
-
3
