ASSEMBLY INSTRUCTIONS
(For Models KS8190, KS8191, KS8390, KS8391, KS8200, KS8290, KS8291)
IMPORTANT: Tighten the fasteners as directed
in each step.
Before assembly, set disk clutch in middle
position for ease of setup and balance of stand.
(as shown).
Take bottom right foot with Yellow sticker and
fit it on the X-leg. Line up the Yellow sticker on
foot with Yellow sticker on X-leg. Secure in place
with fastener. Leave stand in the upright position
to complete assembly.
Take bottom left foot with Green sticker and
fit it on the X-leg. Line up the Green sticker on
foot with Green sticker on X-leg. Secure in place
with fastener.
DOUBLE-X MODELS ONLY: Repeat steps 1
and 2 for the rear X-leg. Continue to Step 3.
Take top right arm with Orange sticker and fit
it on the X-leg. Line up the Orange sticker on
arm with Orange sticker on X-leg. Secure in
place with fastener.
Take top left arm with Blue sticker and fit it
on the X-leg. Line up the Blue sticker on arm
with Blue sticker on X-leg. Secure in place with
fastener.
1
2
3
4
1
2
3
4
IMPORTANT NOTE:
The FRONT SET of
X-legs on all Double X
models has the disk
clutch.
Blue
Orange
Green
Yellow
© 2003 TMP, Inc.
www.onstagestands.com
www.musicpeopleinc.com
-
1
