ASSEMBLY INSTRUCTIONS

(For Models KS8190, KS8191, KS8390, KS8391, KS8200, KS8290, KS8291)

IMPORTANT: Tighten the fasteners as directed

in each step.

Before assembly, set disk clutch in middle

position for ease of setup and balance of stand.

(as shown).

Take bottom right foot with Yellow sticker and

fit it on the X-leg. Line up the Yellow sticker on

with fastener.

DOUBLE-X MODELS ONLY: Repeat steps 1

and 2 for the rear X-leg. Continue to Step 3.

Take top right arm with Orange sticker and fit

it on the X-leg. Line up the Orange sticker on

arm with Orange sticker on X-leg. Secure in

place with fastener.

Take top left arm with Blue sticker and fit it

on the X-leg. Line up the Blue sticker on arm

with Blue sticker on X-leg. Secure in place with

2

3

4

IMPORTANT NOTE:

The FRONT SET of

X-legs on all Double X

models has the disk

clutch.